I recently replaced my fuel sender and it has the extra nipple for a return. I am currently running a single-in, single-out fuel filter which I...
I have a 75 CJ5 and am looking for the decal that is applied over the stamped Jeep Logo in front of the door openings on each side to make it more...
Santa allowed me to "stumble" across a T18 Wide-Ratio/Dana 20 Combo with a bell housing for $350. It is out of a post 76 Jeep and was behind a...
I thought I asked this months ago, but cannot find it. I am trying to calculate the amount of lift I have between shackle reverseal, 76' Springs,...
I currently debating installing a twin-stick on my Dana 20. The PO "Lincoln Locked" my Dana 30....and until I upgrade to a D44 I was thinking of...
Just took the Jeep for the first drive today after replacing the motor and clutch. I had a heck of a time adjusting the clutch but things worked...
Just got my 75 moving after a full rebuild....all new clutch parts and clutch pedal linkages except for the bellcrank. (Had a wacked out...
Just finished putting a new dash in and rewiring my 75 CJ-5. I used aftermarket gauges, but kept the original Speedo. All the lights are...
I am rewiring my Jeep from scratch with the EZ-Wire 8 circuit kit and a Signal Stat 900 turn signal switch. The Signal Stat has two wires Yellow...
The PO of my Jeep installed a Grant Steering Wheel. In addition he really messed up the threads on the upper shaft. The nut just slides on and...
I am trying to figure out how much lift I have on my 75. Could somebody with an unlifted Intermediate CJ5 let me know the height from the bottom...
Trying to figure out the best place that is easy to access. Would like to stay away from the engine compartment. Has anybody mounted it in the...
Search didn't answer my ??? I have a 75 CJ-5 with converted disks on the front, 11" stock drums in back. I have a YJ booster/mc assembly and...
Currently putting a 360 into my 75 CJ5 with the org. T-15 3-speed trans. Since the new flywheel is drilled to accept 10 3/8" clutch (Org. to my...
Have a 75 Jeep CJ 5 and I cannot seem to find a replacement rearmost crossmember for 75 and before. I am looking for the rearmost crossmember at...
I am swaping my wasted 304 to a rebuilt 360. I have ordered, but do not have my new flywheel yet. Do all the 360's use the 11" clutch, or did...
I have a CJ5 with aftermarket springs, reverse shackle, shackle lift, and SOA done by the PO. My front drive shaft has way to much play at the...
Hello, have a 75 with flanged axles. There is about 1/4" of in and out play on each side. Is this ok, or what does it mean? There is no...
I appreciate all's help on my ongoing fix-up project. I am currently investigating rebuild possibilities and have found out I can actually...
Bought my CJ a month or so ago because I really wanted to expand my wrenching ability and needed a new hobby. This CJ is not letting me down....
Separate names with a comma.