I was in your driveway and do not remember it being any steeper than a hill I have climbed with no problem near my house. The only time I had a...
Looking good!. Can't wait to roll up beside you with mine and compare notes.
I recently had a problem with my JEEP where it would be running perfect, then all of sudden act like it was starving for fuel, then quit. When...
I just used nuts and bolts in the hopes that I wouldn't be taking it on and off very often. Having a plate or something on the inside would have...
Congrats on the progress. i can certainly remember the "this is fun but I want to drive it" feeling. Looking at these pictures and reading your...
I used the BFH method. The problem I ran into was the steel folded over in a bad place and I ended up having to cut and weld some. And of course...
A few years back (wow! Alot back, like 1999) I hit a curb with my fairly new at the time Silverado and broke the bead on my aluminum wheel. I...
:cheers: VERY nice!
The first time I lined up my tub holes with the frame holes I started with the hole on the D/S floor pan. I had a hard time getting the other bolt...
I'm thinking about slapping together a second one that I can use for, well, all the stuff a JEEP was made for - without worrying about getting it...
x2 On my '60, I got two large holes PLUS two mounting holes per side. The large holes had to be drilled right through the mounting brackets on...
It seems to me, and others may disagree, that what they are referring to as "facing" may actually be the sides/rear and that the light gray is...
My 1960 had one seat that looked just like yours. I went with black though 'cause light colors and me just don't go well together. ;)
I saw how you described your project and I thought, "Hey, I have a picture of one of those" so for added inspiration (as if you ever need more)...
[IMG][/IMG] There's something about this picture that just says winter - 2012 calendar. :)
I know this sounds too obvious but did you check that the wires are in the correct firing order. Mine did the exact same thing and I discovered I...
I used an inverted flare plug in the tee where it split off to the fuel pump.
Been there... [IMG] done that! :rotflmao::rotflmao::rotflmao: [IMG]
I worried about doing that to mine for a long time but then when I did it, it was fairly easy and works well. I'll try to get some pics tomorrow,...
Got mine from Willys-Overland in Toledo. Shipping them is ridiculous for what they cost so if you need something else... They are $1.50 each....
Separate names with a comma.