I'm working on wiring in my electric fan and I would to put in a buzzer that buzzes when the fan is off. I was going to use a Cole Hersee 4099...
Installed the Delco 12 Si and wired it up as recomended by thousands of threads on the internet, but I have a problem. At initial start up the...
I have a Rochester 2g with an automatic choke on my Flatty and I'm not sure how to hook up the choke. I think it might have been hooked up to a...
So I went and swapped out the throttle on my TJ as described on a few of different forums. I reused all the 2.5 sensors hooked all the cables...
I was doing some research on the spline counts for the 73 cj5, and I believe that the box side is 3/4" by 36 splines. What I'm not sure about is...
Will a electric fan the moves 1,250 cfm of air cool a 225 V6 with a stock 2a radiator all stuffed into a the 2A's engine compartment? I...
Is there a difference between the 2.5 four cylinder, and 4.0 six cylinder intakes? I've looked at both and they seem pretty close to me. I been...
My service manual for the 225 buick says the clearance between the pump cover and gears should be between, .0023 and .0058. Is that right or did...
The defroster's in my '97 Tj are not working, sorta. I've done some reading on the matter and seems that the air diverter thingy will break at...
I'm joining the "Quitters Club". I've decided to sell and replace my CJ5 that I have been using for a DD for 3 years for something a little...
I wonder why I can't seem to finish my Flatty. I picked up a Bantam TC-3 from another forum member that was fairly local to me. Here is the...
I want to mount a 7.50x16 tires on my flatty. I planned on using the factory 16x4.5" wide rims, but the guy at the tire shop said I should have...
After much fuss and swearing I finally manage to get the distributor out of my 225 but I broke it in the process. I have a spare that I'm going...
Really dumb question:oops:. I was looking on the Petronix site and they said for a 1970 225 I need the 1162A kit, but it dosen't fit:evil:. I was...
Did AMC use a harmonic balancer on all it's V8's all through out their run, or just after 1974. I was looking On jegs' website and it does not...
I have been working on this rebuild for quite some time now. This is my rebuild of my 45 MB/CJ conglomeration of a Jeep. Before I get hazed...
Hello. You've mentioned a few times that the transmission mount that Novak sells is very similar/the same as ones used on Chevy truck...
I've finally got around to working on my flatty again and am to the point again where I want to mount my motor. I've read and reread the...
I'm tired of screwing around with the jacked up wiring harness for my '73 cj-5. When I get the time and fund's I wil replace the entire thing,...
I can not get my Cj5 to charge and it is frustrating me. It has an externally regulated alternator. I traced, reparied and properly connected the...
Separate names with a comma.