my clutch squeaks a bit once when letting it out cold, then is fine entire driving session. I am going to check clutch adjustment this week, any...
I am wondering if there is an alternative filter to a purolater l20033 3.77OD filter. I just crammed in the 1" mount tab Powermaster alternator I...
Did a 304 72-75 Cj-6 exist factory?
Is it possible to simply loosen the engine mounts and isolators and slightly jack up the engine to facilitate replacement? I look to refresh mine...
I've searched and read up. I understand I will have to grind down an alternator case to around 1" to clear the AMC upper bracket, and probably...
I am looking to do an 'el-cheapo' sound solution that is as unobtrusive as possible. I have the vinyl renegade rear pads over the wheelwells so...
I have one of these and it works. [img] IS 30wt straight oil the right lubricant? anything is better than the cloudy junk that was in it,...
I am picking up a mech gauge to replace my electrical renegade gauge which I believe has issues to determine more, but I do have a few questions....
Can someone tell me the size of the vaccum hoses used on my 304? they are all so old they are stretched or shrunk to all manner of OD and ID and I...
Well folks, after plugging away this winter, I am close to the road again on this sickly Jeep so far I have done: starter and cables...
Anyone know a 'go-to' place via web or phone to order up the bolts and fasteners required to install stock manifolds on a 304? I likely finally...
anyone know of a good source for a rebuilt 2100 carb ? Napa has one listed for my 74 304, but I can't tell for the pic if it's the...
missing a simple part(s). I need the size or source of the rear brake hose bolt to axle and probably the seal/washer beneath it, much like the...
I have noticed through searches this, well, happens. PO cracked dipstick tube with botchy header install. Gave out flush with block pretty much...
I was wondering if exhaust manifolds for an AMC Javelin 304 are the same as Jeep 1974 304? I have found a set advertised as such and I need...
I have no idea what brand/model headers are in this jeep. They are in frame. The driver's side collector flange and pipe meeting allow the...
The stock carrier on my 74, what size or total weight can it really accommodate? Or am I best off to remove it and not use it at all?
My 74 came with no center latch for the hood, probably a large part of the reason the hood had to be repainted. :) I found an NOS one. two...
Is it acceptable practice to flush a t-15/d-20 with 20 or 30 straight weight, statically, and letting it dump out before gl-4 refill? or does it...
WIll a 6 foot 5/16 section replace the factory run? I have a completely incorrect one to address so no template to go by.
Separate names with a comma.