slow and steady as she goes! finally getting some welding done. got the d rings installed along with the u bolt flip kit. [IMG] [IMG] [IMG]
Ok, I'm back! got married and had a baby boy, whew. now i'm ready to start working on this jeep again. I drilled out the spindle to accept these...
i have pondered the same idea. i also thought about "rhino lining" the whole cab. but i'm concerned about weight and looks. i didn't know that the...
detailed, very detailed. keep up the good work
super clean. nice work. show room condition!
the tub probably weighs around 400 lbs???. so 4% of 400 is 16lbs. i would take 16lbs over rust any day!
http://www.rockcrawler.com/techreports/bigdaddy_cj_tierod/index.asp check this site out. if you want to beef it up i suggest big daddy tie rods.
www.AffordableBender.com check this out
how much more weight does all that stainless add? it's basically bullet proof!
yep, the clutch set up came like this when i bought it. i just had to make some minor adjustments to make it work. thank you. i've had so much on...
[IMG] [IMG] ran a some strips across the front and back of the x member. i need to unbolt it and finish welding it up.
[IMG] [IMG] [IMG] front and rear bumper welded on. this should give it some rigidity.
[IMG] [IMG] lever compressed
[IMG] [IMG] [IMG] [IMG] [IMG]
google image "jeep master cylinder push rod"
my rod dies not look like the one you have. i also have a 70 so i'm not sure if they changed these or not. i sent you a pm. i can show you pics...
http://ok4wd.com/catalogsearch/result/?q=tie+rod i found these inserts, they dont require welding. they sell the whole flip kit.. hmmmm
it looks like goferitoffroad has the inserts but not the tie rods. i can order the tie rod from bigdaddyoffroad and i have to get the moog from...
thanks for the great advice, i will order the monster tie rod from bigdaddyoffroad.com and get the moog ends. the 79 dana 30 is considered a...
Have any of you upgraded your tied rod and used heim joints? How long of 1" o.d DOM tubing should i buy? where am i supposed to measure on each...
Separate names with a comma.