F head Vacuum and pcv valve

Well, I have my oil bath and my new heater and switches. I was looking for a vacuum source (still new at this) and with research and searching on this site found this
http://www.film.queensu.ca/CJ3B/Engine/Rebuild8.html

Just looking for a little verification and parts assistance. According this this the vacuum source is located just below the carb on the right side. One line of the t fitting runs to my heater switch assy. Then from the switch assy two line go to the heater plenum. The other side of the "T" goes around to the pcv valve which is connected to the left side. I do not have vacuum wipers so this should finalize it. Correct?

CURRENTLY, I have a straight rubber line line going from the right side directly to the left side. No PCV valve.

Does anyone know where I can get the t fitting and lines need to complete the routing to the heater switch and to the PCV valve to include a PCV valve? I have seen NAPA being answers to many questions and am going to swing i there this weekend, but was looking for someones experience with this and also to ensure I understand the routing process for the lines.

Sorry for the long post. Thanks a bunch.

 

Wow. No takers. Either I have hit a super low on a tiring subject or ....? Anyway, I will bump her back up to the top.

Thanks

 

you have the right idea
parts store would be the place to get the fittings
nothing special about them at all
following the write-up posted above will guide you along
when I had my F4, it was plumbed the same way
I think even the PCV valves are available thru flaps