I Need A Trans Tunnel

Hello
I'm at the point in my 1970 renegade 1 project that I need a trans tunnel. I've got some feelers out but I thought I'd broaden the search. If anyone has an old body that they are parting out? I have included a few pics of what I need.

thanks
Sean

 

Where did you get your replacement floor? It looks like Midwest Military from the correct recess stamped by your level, and the two-piece design for under the seat (tank on earlies). I'm curious if anyone else carries the correct pieces.
-Donny

 

I’ll check my pile o stuff tomorrow

 

Midwest military yes. They fit pretty good and the hat channels line up great. The drain holes are out of position but I don’t care.

 

Mine was pretty bad and I fabed the rear half and patched a bit. This might be one of the easier parts to make yourself.

 

I have a 67 CJ5 body that I am not going to use in my barn. I was planning to offer it on the forum for anyone needing a panel.

I think that portion of the body is good, but will go down and verify that, and take a picture or two.

Shipping shouldn't be too bad.

I will have to tow the Jeep up to the garage where I can get at it with my die grinder and air chisel.

 

Just went down and took a look. I must have been dreaming about that portion being good, several inches have been cut off the driver side, and there is rust through on the piece under the tool box worse than the one you cut out.

Sorry.

 

Thanks for looking. I appreciate it.

 

Everything I got around is worse than yours lol