1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Is it possible...

Discussion in 'Early CJ5 and CJ6 Tech' started by Old Bill, May 15, 2005.

  1. May 15, 2005
    Old Bill

    Old Bill Aggressively passive....

    Really Southern...
    Joined:
    Nov 12, 2004
    Messages:
    822
    To get your hand inside the inspection cover hole to undo the fork and T.O. bearing spring to aide in tranny removal? F134 and T90 I'm talking about...

    And because I've got big ol' gorilla mitts, is there an alterate way to get the tranny free without taking off the bellhousing?

    TIA
     
    Old Bill, May 15, 2005
    #1
  2. May 15, 2005
    gte636p

    gte636p Member

    smyrna, Ga
    Joined:
    Sep 23, 2002
    Messages:
    492
    you should be able to unbolt the tranny from the bellhousing without having to play with the floorboard panels... and i haven't played with the f-134 housing, but i have been able to put the fork and springs in an l-134 bellhousing without too many problems. then again, i don't think my mits would qualify as gorilla mits either...
     
    gte636p, May 15, 2005
    #2
  3. May 15, 2005
    lostexan_78

    lostexan_78 Sponsor

    San Antonio, Tx.
    Joined:
    Dec 1, 2004
    Messages:
    67
    mine are big I just got through pulling the engine yesterday, had to undo the floor panel.
     
    lostexan_78, May 15, 2005
    #3
New Posts