1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

question

Discussion in 'Builds and Fabricators Forum' started by Drifter, Oct 26, 2005.

  1. Drifter

    Drifter Luke the Drifter

    I have a set of m38a1 parts I picked up for free when I went and got my v6 that's I'm swapping into my 2/3a project. well these springs are in much better condition than what's on there now.

    Anyone know if you can use the a1 springs on a 2a?

    Luke
     
    Drifter, Oct 26, 2005
    #1
  2. Boyink

    Boyink Super Moderator Staff Member

    IIRC they'll be longer than your 2A springs...but since you have the 2A there it should be easy to compare...
     
    Boyink, Oct 26, 2005
    #2
  3. jd7

    jd7 Sponsor

    jd7, Oct 26, 2005
    #3
  4. sparky

    sparky Sandgroper Staff Member Founder

    I was just looking at that wondering what flattie springs were David.
     
    sparky, Oct 26, 2005
    #4
  5. Mojave

    Mojave Member

    Easy enough to measure - We measured mine at one time, and figured that the fronts off the M38A1 would fit the rear of my CJ3A, and the rears might fit on our CJ6. Too many leaves though - would make for a very rough ride.
     
    Mojave, Oct 27, 2005
    #5