1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Help...T 90

Discussion in 'Early CJ5 and CJ6 Tech' started by T Todd, Mar 31, 2006.

  1. Mar 31, 2006
    T Todd

    T Todd Mostly Confused

    Frazeysburg Ohio
    Joined:
    Jan 14, 2005
    Messages:
    111
    Well I managed to pull the main shaft and input shaft apart and lost the rollers. Is there any way to re stack them without lowering the intermeadiate shaft? Maybe like tapping the rear bearing adapter out and lifting the mainshaft up and out?
     
    T Todd, Mar 31, 2006
    #1
  2. Mar 31, 2006
    Glenn

    Glenn Kinda grumpy old man Staff Member

    Apopka, Fl
    Joined:
    Sep 21, 2002
    Messages:
    12,381
    The rollers go in the end of the input shaft. I'm not exactly sure what you're asking since you obviously got it apart far enough for them to drop out. The counter shaft has about 4 times as many rollers, and smaller too. If you remove that you're in for a lot of fun. Or are you going to disassemble you're transmission totally? Doesn't sound like that's your plan but just wondering.
     
    Glenn, Mar 31, 2006
    #2
  3. Mar 31, 2006
    T Todd

    T Todd Mostly Confused

    Frazeysburg Ohio
    Joined:
    Jan 14, 2005
    Messages:
    111
    I got them back in. I didn't want to drop any dirt back in after the rebuild so I took the tie wire off and set the shifter on, BAD IDEA #1, then I decided to test fit the transfer case without the gasket to make sure it would fit up ok, BAD IDEA #2, but when I slid the xfer back off to install the gasket it pulled the mainshaft back just far enough:mad: I've really got to work on getting all my stupid mistakes out at work before I come homeR) But it's together now and I can put it in the JEEP tommorrow.
     
    T Todd, Mar 31, 2006
    #3
  4. Mar 31, 2006
    jpflat2a

    jpflat2a what's that noise?

    Hermosa, SD
    Joined:
    Jul 30, 2003
    Messages:
    8,525
    hope you got them all
    there should have been 14 rollers total
     
    jpflat2a, Mar 31, 2006
    #4
  5. Mar 31, 2006
    Old Bill

    Old Bill Aggressively passive....

    Really Southern...
    Joined:
    Nov 12, 2004
    Messages:
    822
    IIRC, if you have all the rollers, the last one has to slide in from the end. Kind of like the keystone in an arch.
     
    Old Bill, Mar 31, 2006
    #5
  6. Apr 1, 2006
    speedbuggy

    speedbuggy Looking for a Jeep now

    Living the Good...
    Joined:
    Jul 1, 2004
    Messages:
    1,270
    Purdy! Mine will look like that this summer ;)
     
    speedbuggy, Apr 1, 2006
    #6
New Posts