Finally Started on my bumper

I drew this bumper out almost a year ago , then I did it in sketch up about 6 months ago. Heres the drawings (followed by the progress)





The high lift is holding the bumper in place for inspection . I did more to it after those pics were took but my camera mem was full.
Nick made one similar after seeing it but angled the ends and used a diff D ring attachment point . Im going to angle my ends after seeing his but not as steep and Im going to keep my attachment points. Right now they are the hold up because thay are going to be made of 1 inch plate which I have plenty of Im just lacking the patients to cut and drill them I think Im going to need a few for that part of the operation. Ive also updated the sketch up drawings incorporating the tire carrier and a few tweaks . Like a brace / safety chain attachment points under the receiver hitch. Tommrow Im going to get the tire carrier mounting hardware in place. Hopefully Ill have it done over the weekend..

 

Looks good so far.

 

looks good Jason

 

looks good.Cant wait to see it finshed.

 

Kinda looks like mineR) wonder where you got that idea from:? R) R)

 

So is that what you have been doing lately. Looks good, as good as something Nick would make

 

Hey just because you got yours built first doesnt mean you came up with it ..R) Someone has got to test this stuff out R) R) R)

 

I did not take credit for the idea, just perfecting itR)