help wiring

I am so damn confused... PO put a GMC (unknown model and type) column in my 71 CJ5... can some one please ID these wires for me?

 

there is no wiring for the wipers.... yes i want to use the turn signals/ dimmer switch and ign switch

 

I have a picture of the wiring for the GM connector but need your email address to send it direct. My system wont let me e mail here. Larry

 

Check your PM, I am sending you a link that may help.

 

sfaracing@yahoo.com

 

I recognize that connector as being the same as the '84-'96 Cherokee XJ; might want to browse www.naxja.org

Do you have the sliding-rod style ignition switch on top of the column under the dash toward the firewall?

 

Try this:
G - blk - horn
H - lt blu - lf turn
J - dk blu - rf turn
K - brn - hazard flasher
L - ppl - ts flasher
M - yel - l stop/turn
N dk grn - r stop/turn
P - wht - stop switch

 

let's see if this'l help What you have pictured is the turn signal, hazard section


the ignition section is on the right hand side of the colom, without the clips - it looks like this, the green lettering on mine, did not have a wire comming out


the plugs that go into the ignition switch

and


the head light dimmer switch


I have working on this set up: Running lights, headlights high and low, turn signals, 4 way flashers, ignition start and run.

Have not figured out the brake lights, have a switch wired to the hanging pedals, also, something in my colom is wrong with the horn switch as I do not get any continuity through the horn wire.

Hope this helps, colum is a tilt colum from a 92 XJ, but my 94 GMC has a similar set up, also, the 78 cj7 had the similar wire harness - very common set up

 

man, looking over what is posted here, what I have, and that which is above, I think I may be able to figure out my dilemma with the breaks. - NOTICE that on the first harness I posted, the wires and colors going in, are not the same as those coming out - a local repair shop owner has been assisting me with IDing what I have and what goes where. Here is what I mean - lines drawn straght through - some clarification would be helpfull to myself included, as I believe I have some correctly ID'd and some needing to be re-labled.

PLEASE SOME ONE HEEEELLLPPPR)R)R)

 

I may have just had a brain fart - I noticed on my clip, the white wire, ID'd by Dave 74 is for the brake switch and DOES NOT GO THROUGH THE CLIP - mabey, I could cut it and bypass the clip?

 

ok - all is well - I broght power to the brake switch which is activated by the hanging pedal and tied it to the white wire that I just relized did not go through the harness clipp. Walla - all is good in the world of lighting.

Brake lights are DONE