1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Closed knuckle bearings?

Discussion in 'Early CJ5 and CJ6 Tech' started by jutgin, May 13, 2008.

Page 2 of 2
  1. zed

    zed Iowa- Gateway to Nebraska

    Yeah THAT's the one I was talking about. I used both that one and the one from the FSM. Between both of them it's pretty clear.

    While I had them apart I also did the spindle bolt upgrade on Dr. Vern's site but it's not necessary to do that also.
     
    zed, May 22, 2008
    #21
  2. jutgin

    jutgin New Member

    Well I have it all apart.That's all for today. Fragments of bearings everywhere.
     
    jutgin, May 22, 2008
    #22
  3. jutgin

    jutgin New Member

    Well isnt there supposed to be 4 bolts in each cap? 1 for each hole?
     
    jutgin, May 24, 2008
    #23
  4. lamar

    lamar Member

    1 for each hole,4 per cap,8 per knuckle
     
    lamar, May 24, 2008
    #24
  5. jutgin

    jutgin New Member

    I was wondering why the top cap was missing 2. I'll search for those bolts on one of those parts sites. Other than that it is done. wasn't that bad and thanks for all the help!
     
    jutgin, May 25, 2008
    #25
  6. kaiser krawler

    kaiser krawler kaiser krawler

    take one of your old bolts down to the parts store a get some new ones, they are just 3/8 bolts. your local store should have some.
     
    kaiser krawler, May 26, 2008
    #26
Page 2 of 2