1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Wiper Motor Cover Screws

Discussion in 'Intermediate CJ-5/6/7/8' started by OleBlue, Jan 13, 2011.

  1. Jan 13, 2011
    OleBlue

    OleBlue Sponsor

    Tennessee
    Joined:
    Feb 14, 2010
    Messages:
    1,001
    I have searched and read where JB Weld can be used in stripped screw holes to have something for a new screw to screw into. I have the stripped hole issue with my wiper motor cover. Has anyone else done this or did you just use larger screws?
    Posted via Mobile Device
     
    OleBlue, Jan 13, 2011
    #1
  2. Jan 13, 2011
    DREDnot

    DREDnot Not new to JEEPS

    AZ
    Joined:
    Feb 7, 2010
    Messages:
    646
    I'm sure it would work fine as those screws just hold the cover on.
     
    DREDnot, Jan 13, 2011
    #2
  3. Jan 14, 2011
    sterlclan

    sterlclan Member 2024 Sponsor 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,903
    if you grease the threads you can fill the hole with jb and stick the bolt in after it cures itll back right out............................99% of the time:rofl:
     
    sterlclan, Jan 14, 2011
    #3
New Posts