Please Help!!! Engine installation hardware

I am finally ready to install my freshly rebuilt 258 into my 75 CJ5. I took this motor out over a year ago with the intentions of rebuilding it in a month. Ended up doing the T-14 and Dana 20 while i had them out. Now that I am ready to put it back in i am kicking myself for not doing a better job of recording where bolts went. I also need to buy a lot of new hardware since the dufus PO stripped everything he could. Here is the list so far of info I need to get her back together: I would greatly appreciate any help you can provide.

1. The bolts that hold the mount bracket to the block, do they have a lock-nut, washer, or is it one of the bolts with the washer built in?

2. Same as above for the bolts holding the transmission to the bell housing + length.

3. My mounts go in opposite of the what the Chilton manual says, on mine the single hole goes down on both and into a slot on the driver side mount( I think)? Is this correct?

4. If anyone has a 75 or like model with a 258 could you please take some pics of your engine bay from all angles and post them?