Correct bell crank diameter.

Hey guys, I've been searching and haven't found the correct diameter for the bell crank shaft on my 68 cj5. I'm thinking I'll need the 1 1/8th inch rebuild kit listed on this page: http://walcks4wd.com/steering-group/bell-cranks-bell-crank-kits.html I'm also going to pick up a new crank and drank link to try and tighten up my sloppy steering. Anyone know for sure that the 1 1/8th kit is the one I'm after?

Also, I had to edit this post because I forgot to ask, does anyone have a source for stock length front and rear spring shackles?

Thanks in advance.

 

My 68 cj5 takes the 1 1/8. Did you check the sticky on the shackles? I'am not this far yet so I'am no help there.

 

These are the ones on my '60 CJ5: http://walcks4wd.com/shackle-kit-silent-block-type.html

and these are the ones for before '57 CJ's: http://walcks4wd.com/u-bolt-shackle-lh-hand-thread.html and http://walcks4wd.com/u-bolt-shackle-rh-hand-thread.html