Where to drill motor mount holes on a fresh frame???????

Well not exactly.

I have an AMC 360 that is getting put into a DJ5. I pulled the engine from the DJ 5 and found that it used a full crossmember under the engine, and that the crossmember did not use any of the same bolt holes as the typical CJ mounts.

I'm going to hang the AMC 360 with some MORE BombProof mounts, I have these mounts in the garage, so I can use them for mockup, but thought I might ask here and see if any of you have the measurements or perhaps templates that show the factory holes for the V8 mounts?

I'm to the point now where I get to start assembly/ test fitting everything. This little DJ has a fully boxed frame, and will be outfitted with a Dana 30 front axle, a Dana 44 rear axle, both geared 3.73, an :AMC: 360 V8 with HEI, a T-15 manual transmission hooked to a Dana 20 transfer case.