Dang it, lost the Tech sheet...

to the carb kit. Anyone have float levels and measuring points for a brass float?

 

OEM manual choke Rochester 2g

 

Carb. No.7027082

Float level 1 5/32 from gasket to top of float at toe.

Float drop 1 3/4 from gasket SURFACE to bottom of float.

Give me a carb. No. and I can give you more info....

 

Is that for a brass float?

 

Sorry Rocky.....No Brass float specs. in my book.....DANG IT...

 

Dang it all.

 

Those measurements will work for the brass float for the 7027082.

 

My carb is a 7041185 manual choke. Here are the specs that came with the quadrajetparts.com kit:

Float level: 1-5/32"
Float drop: 1-7/8"
Pump rod adj. : 1-1/16"

Float measurements are from gasket surface to top of float at toe. I purchased a brass float from the same place and used these numbers, although I haven't started the rebuilt motor yet. Let me know if you need more info.

 

Patrick is correct.
I'll try and check tomorrow. I think I still have the tech sheet from the Daughter's carb rebuild.


Sent from my iPhone

 

Thank you. It would be a blessing.

 

SM-1046 gives 1 3/32" for standard and 1 5/32" for emisson controlled with air injection for upper end and 1 7/8" for drop. Pretty sure that data is for brass float version like the carb that came on my 68.

 

The picture in the SM1046 is showing the fiber float not the brass.

 

Fwiw, In my 1967 parts book there is no mention of a brass float......on the 225.

 

My Echlin rebuild kit info says 1 5/32" float level and 1 7/8" float drop. It specifies with a brass float to measure with gasket in place and measure from the gasket to the sharp edge of float seam at free end of float.
This is for a 1971 225 listing.

Sent from my iPhone