I attempted it. actually, I purchased a power steering box from a wrecking yard and tried to see if it would fit. My application did not work....
Anyone out there powder coat your entire trailer. I got a deal on blasting and powder coating. I was only going to only do do the frame but...
found the site. http://www.swracecars.com/shopping/shopdisplayproducts.asp?page=1 part number: 11-2591 anyone ordered or know anything...
Somewhere I read that you can purchase a full roll cage (unwelded) as a kit for jeepsters. I now can't find where that is. does anyone know of...
good input. I was going to install a rooftop tent on mine (too much $$), but when I saw this one I thought I would check it out. I will probably...
Has anyone looked at installing one these on an M416 trailer?...
those things can go for some good money on ebay.
I have used a bushing from a evap cooler on 2 jeep builds. They are cheap and you can oil them with the supplied spring cap. Works great. I...
I also am thrilled to see this section added. I am neck deep in a 69 jeepster build up and would love to see others with same passion (vise)....
I would suggest doing a SOA. Look for a used set of wrangler springs. They will sit flat and provide a softer ride and should provide enough...
could not figure how to upload pictures to email message. here they are.
If you are running a Dana 18 offset axle in the rear, I would suggest looking into getting axles from a mid to late 70's wagoneer or cherokee....
Separate names with a comma.
