Thanks!
Hello all, My engine (F-134) had a brass hose barb fitting in the timing cover where the oil filter return line goes in. That brass fitting was...
Thanks! That is perfect. I am going to try and fab something up this weekend. I will try and get some drawings of the parts once I have a...
Can you show a picture of where the driver's side bolts to the floor near the middle of the jeep? I can see where the outside bolt goes, but the...
Hello All, I drove my CJ5 for the first time since beginning my project, even if it was for just a few feet. I need seats. What is the best...
Hello again, A quick question for the forum.... What kind of fitting is it that goes into the bottom of the fuel tank? It appears to be some...
Perfect. Thanks for the tip. I got the front replaced today and hope to do the rear tomorrow. Next up... steering box clean up and new seals....
Hello all again. I am now going to replace the oil seals around the yoke in both differentials. I was able to get the nut off with a pipe wrench...
Anyone have a dorman part number for the right wheel studs or am I going to have to break out the calipers
I have gotten them all removed and are putting the new brakes together. Question: Should I drill out the holes on my new drums to fit over the...
FSM?
Thanks for all the help with my previous thread. I have made significant progress and am almost done with the tear down. I need to remove the...
Separate names with a comma.