1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

1962 CJ5 Michaels Project

Discussion in 'Builds and Fabricators Forum' started by chris423, Jan 27, 2015.

  1. chris423

    chris423 Sponsor

    test fit[​IMG]
     
  2. chris423

    chris423 Sponsor

    test fit[​IMG]
     
  3. chris423

    chris423 Sponsor

    just primed top of bed[​IMG]
     
  4. chris423

    chris423 Sponsor

    air compressor and I have been trimming out a house more this week
     
  5. uncamonkey

    uncamonkey Member

    Just saying I used to have a 110V flux core machine, It was stolen so I got a 220V with shield gas. Much better welds and the ability to do some heavier metal. A friend does jobs like power plants and refinerys. At the end of the job they sell all of the equipment. If only I had the $.
     
  6. chris423

    chris423 Sponsor

    I have to catch this up sept1 the tub was removed from the frame . it sat on the roll bar and sawhorses while I plug welded the rear floor in. now it sits on the passenger side so I can weld all I can get to . the a supports in the front by the engine and master cylinder are history working on some 2inch angle for replacement so far so good . the frame was pressure washed . I paid special attention to where I have heard of cracks so far so good on that no cracks but the fame was boxed in all around the engine Is this stock????
     
  7. chris423

    chris423 Sponsor

    [​IMG][​IMG]old and new
     
  8. chris423

    chris423 Sponsor

  9. chris423

    chris423 Sponsor

    old passenger side [​IMG]
     
  10. chris423

    chris423 Sponsor

    This will be a driver. I am doing my best not to BUBBA engineer, after all this is a first for me and my son ! Oh thanks to Ron in Va I have a complete E-brake !!!!
     
  11. rejeep

    rejeep Well-Known Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    for my time I am very happy with the aqualu tub...
    but you are doing a great job with lots of patience repairing that tub :beer:
     
  12. chris423

    chris423 Sponsor

    Thanks It has taken some patience with the tub . The rust is never ending ! Yesterday I got the bottom primed . And now the rain has started . We will see how it will hold up . !!!
     
  13. chris423

    chris423 Sponsor

    What to do in the rain [​IMG]tailgate repair the usual rusted out bottom by the hinge slots [​IMG]when done it wont look new but neither will the rest !!!
     
  14. chris423

    chris423 Sponsor

    [​IMG]still not complete ! but a lot better than bondo over the rust hole
     
  15. chris423

    chris423 Sponsor

    painted and cleaned up the e brake drum and backing plate[​IMG][​IMG]
     
  16. chris423

    chris423 Sponsor

    just n update started bed ling the bottom and then the went the temps above 68* so I have been messing with engine compartment also the heater unit pics to come . the fan motor works and is 12v
     
  17. chris423

    chris423 Sponsor

    why my heater wont work
     
  18. chris423

    chris423 Sponsor

    the bottom
     
  19. sterlclan

    sterlclan Member 2024 Sponsor 2022 Sponsor

    You do not have permission to view media within this album.
     
  20. chris423

    chris423 Sponsor

    can you see the pictures? I change privacy settings on album.