X2 As for whether or not to box it there was a fairly long thread here recently that talked about boxed, unboxed, frame strapping, things like...
If you do like we do sometimes and keep a constant mess in the shop, with oil dry all over the place, you wont have much need for wheel locks. :)...
It should flex enough to clear it, but make sure you have something to support the transmission on the front once the engine comes loose.
If there's enough air in the line there wont be any fluid coming out. Best bet is to try it the way lynn says, some even park it on a hill when...
A lockout shouldn't be full of grease. Take it apart and see if anything looks broken.....if not, somebody before you might have packed it full of...
Just now noticing this thread. Like I mentioned in my pm after talking to you more the only thing I was wondering about is which motor you're...
Which Yota motor is that? And what's it goin in?
5.13's are fairly common around here, because most folks around here run the 14 bolt rear and the 60 front, and up until recently the 5.13's were...
Yup, the 73 has the same set up, or had rather. The triangle part where the ball mounts, even though appears to be really thick and heavy duty,...
Actually, the biggest reason for asking if you were gonna regear the tcase and what I was kinda trying to get to in a round about way was what you...
The wheel isn't in the middle from what I can tell, even though it appears to be. I've seen them in worse shape than that one that have been...
There will be a seperate shifter for the overdrive. Of course the tcase might have two shifters as well, one for Hi-Lo and one for 2wd-4wd, but...
Gotta agree with everyone on just taking it in and having it done, or if you're driving the Jeep just drive it by there instead of taking the...
I personally would just buy new springs, lift springs if you want them, and keep it SUA to save all the other fab work. The rear wouldn't be that...
More of a question really than anything else, but are you gonna be regearing the tcase? I ask that because from what I've seen if you regear the...
In most cases I would say go ahead and put the head and the oil pan on there while you have it on the engine stand, but in the pic it's not on...
It kinda depends on which setup you go with. Since you're name says V8, then the main question is if you're gonna go with the 425 mixer for a 4bbl...
Wait......I'm confused now. You mentioned in your post that it worked, but then toward the end it sounded like you're still battling it. :? After...
X2 basically on all of that, except I would be down in the $1200-$1500 range on price just from looking at it. However, it might end up being in...
Vertically works most of the time as well, just most of the ones we do we like the tanks laying down inside the tub. Something that maybe one of...
Separate names with a comma.