You can get them from your local Jeep dealer, I bought one for my 72 304. The one I bought from 4WD wouldn't fit and I mangled it. The one from...
Will it not start at all, or is it just running crummy? What all has been changed since the last time it was running?
One thing I did was to take two bolts about 2 inches or so long long that will thread into the two bottom holes of the block(the two holes that...
Check local Jeep clubs. There is usually someone parting a Jeep out. In the last 3 years I sold 2 258s in running condition. $100 each and had a...
I don't have a springover. I have a v8/t18/d300 combo with a 2 1/2" lift and a drive shaft that is about 15" long, which is vibrating at road speeds.
$400 is way out of my budget right now. Too many little things to fix. I am running a d300 and I was told a front yoke from a NP231 will fit it,...
I've been looking into rotating my rear axle (78 cj5) and using a CV joint to eliminate vibrations. I've read that you can take a front driveshaft...
All of the brake lines are less than 5 years old, per the PO. While its possible, I really don't think they are the problem. Do the valves...
Good info John. It looks like the brake lines are routed correctly to the MC. But as I look at it again, I'm wondering if the PO put the correct...
Stock disc brakes on the front drums on back, stock master cylinder.
I have a couple of questions about proportioning valves that I have been pondering. It started with an issue on a 78 CJ5 I bought last year that...
As far as the gas gauge goes, I had a similiar problem on a 75. There was a ground wire that came off the sending unit that had a bad connection...
Everyone has their opinion.....I went with one off Ebay. A GM HEI converted to AMC distributor, and put it on my 78 CJ5 w/304. Couldn't be...
Just a WAG, but it sounds like the throw-out bearing may have fallen off during installation. Did you use a new one?
If its not damaged, a $5 tube of RTV will re-seal it, with plenty of RTV left for the next project. That's generally what I do, and don't have...
If its the correct header(s) for that Jeep, they should fit with no mods. Mine do.
Every CJ clutch I ever changed had "This side toward flywheel" stamped into the collar. If your new one dosen't, look at the old one and see which...
Hold the phone....you got my attenion here Nick. I've not heard this before, but sounds interesting. So I can swap in a 4:1 T-19 input...
I've found a conversion to make this transmission work with a Chevy bell/motor, but that's about all I could find. According to Novak's website,...
A while back I acquired a T18/d20 combo out of an early 70s CJ. It is the close ratio, however it did not come with a bell housing or the adapter...
Separate names with a comma.