I just completed my tranny swap and removed my t14 d18 with 10 spline warn overdrive (rear shift) I put in an np435 d18 with a front shift...
Its a little hard to see in photo but I think this is where it was. The wear can be seen where it sat. [IMG]
Thanks for the help, it a np 435 trans, I'm sure it came of of one of the output shafts on the transfercase, because I was resealining the...
Ok I have tore it apart again, I know it came out of dana 18 and not the trans. looks like the only place it would fit is on the front or rear...
Ok I was in the process and finished getting together a new tranny combo swap for my 2a when I found this washer stuck to my cardboard. Shown...
right or wrong, I used a thin washer to the side of the shift levers to tighten mine up Brian
These came off 1969 cj5 v6 w/t-14 trans two spacers on each side [IMG]
I guess I'll pass on the holley pro-jection and just stick with the carter afb I have. thanks for the input Brian
I have searched and read most of the threads hear. For those who have the holley pro-jection and have it on the oddfire v6 what one did you use?...
I will be doing a tranny swap also this summer using the np435 (good deal) on mine for more drive line length, I moved the rear axle back 1" by...
I found that no paint between the springs works the best. ( paint doesn't seem to allow the springs to move on each other) My springs were...
[IMG] these are 32x9.50 15 TSL Superswamper
would their be any where else this washer could have came from? 1 1/2 o.d. and 1 3/16 I.D. 1/16 thick. This is the only thing I can think of...
Did the dana 18 use a washer/shim on one or both sides of the speedo gear? After pulling the rear bearing cap/speedo housing to fix leaks I have...
Nice work, I too spent alot of time making a new clutch assmbly for the same koenig winch. Have you came up with the tension roller to hold the...
Re: diamond plate/rocker guards Its not aluminum for the rocker guards, but it could have been done in steel diamond plate 1 1/2 angle and some...
sounds like something I had going on. Messed with the hei dist., carb settings. ran great at lower rpms and short high revs. Ended up being...
On mine I did the same paint marks on balancer to find out total advance and changed the springs in the distributor to stop over advancing. Also...
If I had to do my dana 30 swap on my cj2a again I would have not let it set in my garage fo 2 years before doing it, should have done it as soon...
Is there an advantage in using a front yoke on the rear instead of the rear 4 bolt that came w/drum parking brake? Strength, driveline lenght?...
Separate names with a comma.