1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Spindle Nut

Discussion in 'Intermediate CJ-5/6/7/8' started by trailcrawler, Aug 11, 2005.

  1. trailcrawler

    trailcrawler Central Ohio Cj'er

    When I went to take the spindle nuts off front axle they were barely on there hand tight. Is this normal? :? Doesn't seem right to me. :AMC:
     
    trailcrawler, Aug 11, 2005
    #1
  2. boxer

    boxer New Member

    If they are to tight they burn up the bearings.
     
    boxer, Aug 11, 2005
    #2
  3. timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    They should only be finger tight.

    I think there's a spec in the later manuals - tighten them to X ft-lbs, then back off N turns. I've repacked front wheel bearings many times, and I just tighten as much as I can with the bare socket, and back off a little.
     
    timgr, Aug 11, 2005
    #3
  4. trailcrawler

    trailcrawler Central Ohio Cj'er

    Thanks for the info I wasn't for sure and have never did them before on this.
     
    trailcrawler, Aug 12, 2005
    #4