transfer case linkage

Anyone know where to get repair parts for a single stick d-20 transfer case linkage. I tried to change speeds the other day and it was so sloppy I had a hard time knowing where I was at inthe pattern had to use neutral as a starting place and try things from there? I don't know if I need to just get bushings or dismantle the thing and weld and re-drill the holes out. Ideas welcome
Thanks

Brian

 

you might try a little lock-tite and snugging up the nuts on the linkage. Not too tight though. That's all mine took.

If yours is just too worn out for that. I'd consider a DIY twin stick for about $8 like this:

http://trailforge.com/cms/index.php?option=com_content&task=view&id=18&Itemid=30

 

I struggled with my linkage. I was not able to find any parts so I got out the welder closed up the holes and redrilled them, It helped a lot.

 

I had the same problem. Fixed it by replacing the whole thing with a twin stick kit off Ebay. Much better now. I don't like how the stock set up worked at all. This has a single hinge now.

High5

 

There's one of the aftermarket sellers that has parts for the linkage - 4-wheel Hardware, Turner's, Walcks, somebody. I wouldn't recommend using the ball-end joints again (I'd try to fit Heim joints), but the rest of the parts (pins and plates) should be ok.