full size waggie axles with out outboarding

i got a 69 cj5 and want to but to put waggie axles under it due the the rear end being offset. can i do this without outboarding the front end ?

 

I dont think so. You may be able to move the spring perches in on the axle, but im not sure if the pumkin will allow for this.
Another thing is your rear end, if the waggie axle is centered it will not work with you spicer 18 t-case. Your ujoint angle will be too severe. Others here may have better info for you.

 

No, there's no room on the front axle tube to move the mounts inward.

 

Yes you can. Problem is you'll have about a foot of axle sticking out further on one side than the other
Posted via Mobile Device

 

even if you weld new axle perchs on i thought you would have to cut one side out further on the passagerside axle pad

 

why dont you have to outboad the rear axle on the jeep but the front

 

because of the diff housing is in the way of where the passenger side spring mounts!

 

the rear diff and front are the same off set right so if the rear fits then why wouldnt the front

 

waggie rear diff is centered for the dana 20 transfercase.

 

right they had some that was off centered they came out of a quadutrack transfer case because i have a dana 18 i have to have the off set rear end but that dont explain why i have to outboard the front spring i should just have to grind open on of the passager side axle perchs and put it closer on the hog head right ?

 

You can't do that to the front because the pumpkin is on the way. Otherwise one spring pad would be up on the pumpkin and one down on the tube. I'd suggest you get out the tape measure and take some close measurements. You'll see why real quick. The rear does not have the same pumpkin offset the front does
Posted via Mobile Device

 

thanks for the info everyone . i blew the t14 in my jeep so the full width axle project is on hold . i gota put a tranny in it . wanting to put grade the tranny with doin alot of extra mods any ideas