1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Windshield swap, help?

Discussion in 'Early CJ5 and CJ6 Tech' started by Im a doughball, Jul 21, 2011.

  1. Im a doughball

    Im a doughball Member

    Picked up a 70' W/S frame to put on the 56'... just popped it on to see where things were going to fall. Previously, the top of the frame to the back of the tub measured 88" +/-, with the new frame, it measures 90" +/-. I've spent the last 30 min. or so searching the forum, trying to figure out how to adjust the angle, couldn't find it. It appeares the rubber seal it thicker than the old one, and his holding the frame up. So, the Q is, are there various thicknesses of windshield rubber? or do I just need to massage what I have until it lays back?

    Thanks
     
    Im a doughball, Jul 21, 2011
    #1
  2. bkd

    bkd Moderator Supreme Staff Member 2022 Sponsor

    Some of the rubber seals vary.......massage it or use the old rubber from the original frame........I'd just leave it and tug into place if using a hard top

    Sent from my DROID2 using Tapatalk
     
    bkd, Jul 22, 2011
    #2
  3. napaguy

    napaguy Banned

    There are different angles on windshield frames...there uses to be an article in the tech section here that explained it well. If I read it right that's what you are concerned with?
     
    napaguy, Jul 22, 2011
    #3
  4. Patrick

    Patrick Super Moderator Staff Member

    Only between the two different styles/ years.
     
    Patrick, Jul 22, 2011
    #4