Centerforce Performance Clutch | Manufacturer of Racing, Street, and Off-Road Clutches Cost is higher than the others. They work well. Have had...
Island Blue Used 1970-71
We did an engine swap in 1959. Bought the motor and put it in with the flywheel. The flywheel works with the Henry J. bellhousing, but will jamb...
Nothing special. Higher compression than stock Jeep motor. Flywheel is different (you will find this out if you put the engine in a CJ).
I have a Centerforce clutch in the J-20. I am suffering from a bad knee revision, but with all of the difficulty in bending, I find myself almost...
Here's a picture of one. I'm keeping a set of 5 for myself. [IMG]
The 1974 model 258 is not the best of the bunch, as far as I am concerned. The 78 I had would run circles around the 72 and the 75 I had, as well...
http://www.addco.net/aftermarket/catalog/jeep/
We did the Jeep thing with the 72 CJ5. 258 with 3-speed trans. Bought it in November, 1971, used as a daily driver and vacation machine. Put...
http://www.advanceadapters.com/products/712502a--chevy--buick-engine-to-jeep-t90-transmission-adapter-kit/
A little over-simplified. It can be done if you like to lay on the floor looking up at the bottom of the motor. If you used the rope-style seal,...
This is the GM-sourced motor [IMG] The later ones are from what I remember a dark green. [IMG] Best picture I have showing the color....
The motors sourced from GM had the Delco distributor and starter. The later ones from Jeep production had a different color paint on the block,...
This should elicit some comment--- Where is your temperature sensor installed--front of intake or to the rear? Early V-6 had the sensor in the...
Overheating is different from running an an optimum temperature. Overheating would be sending the temp gauge to the top. The modern cooling...
Separate names with a comma.