Is there any way to make 2wd low a possibility with stock parts. I can only be in low range in four wheel drive.
The starter on my '63 grinds and does not catch. It just makes a horrific sounding whir/grinding noise, like the starter bendix is grinding the...
I have a '63 CJ5 I recently aquired an aluminum hard top that I was hoping to put on it. The front of the top is approx. 1.5 to 2 inches short...
I really need to find a roll bar (cage) for the '63. Does anyone know where to find one? Or can anyone give me the schematics for one?:?
The fuel line from the tank to the engine bay on the '63 appears to be copper. The line is crimped badly just below the fuel tank. Can I replace...
I have antifreeze leaking down on my drivers side fire wall onto the floor board. I have heard that Bars Leak is bad to use in newer vehicles, but...
My question is mainly for Blevisay, but I desperately need insight from anyone who has the answers. Blevisay advised that he had 2.5 inch springs...
I have yet to grind off the old paint to know what I have. I is a 1/4 ton trailer of some sort that has a track width that matches my '63. I was...
Is there any tricks that I will need to know when I put the new master cylinder on the '63. I have never worked on such a mechanism.
The starter on the '63 engages fine then screeches and free spins. I have to push the Jeep ahead againe with it in gear to spin the fly wheel and...
I have recently installed a 2.5" Rough Country spings and warrior shackles on the '63 netting approximatley 3.25" of lift. I need to know what you...
I believe I have the stock rims on my '63. I measured the rim and from edge to edge is 16". Would that make it a 16" rim or do they measure rim...
Will a Rough Country 2.5" lift and shackles that will fit an up to '71 CJ5 fit a 1963 CJ5.
What do you guys think of the 2.5" Rough Country Lift. Are they quality or not. I have experience with BDS, Superlift, Rancho and Fabtech. I have...
Separate names with a comma.