Helping a buddy upgrade his 78 cj5. He picked up a nice set of axles from a 74 cj5 (flanged 44 rear). The gears were also better from the 74, so...
I am helping a buddy get his 78 moving again for the deer season. He picked up a D44 flanged & D30 from a 73 cj5 to upgrade from the AMC 20, and...
When installing a small block chevy into an intermediate or late cj (long hood), do you have to cut the fire wall and recess it like you do with...
On the old site there was an article about converting to a Saginaw power steering. In the tech article there was a drawing for fabricating the...
Finally have this thing rolling on all 4s. This is the jp magazine designed frame that I fab'ed in the drive way, I'm happy to see it upright!...
Guys, In the middle of my build and I've learned a bit of vehicle "mix-n-match"! One of the things I figured out that may be useful to you guys...
I'm in the process of building an 18 out of a 20 case. I disassembled the donor 20 yesterday and the shaft and needle bearings look and mic...
Does anyone have an old, scrap set of D44 carrier bearing laying around? I need a scrap set to hone out and use for set up bearings...so I can...
I am wanting to run CV joints in the Franken-jeep. Planning on running Chevy 1/2 ton 1310 jointed drive shafts and need CV yokes that fits in the...
I am working on a Dana 44 (flanged) that came from a 74 cj5 for a friend of mine. The unit has the positrac side clutch packs, outboard of the...
I'm looking for the frame mounted eye-to-eye spring perch dimensions on an intermediate cj5. I have a drawing that shows the front is 40.61" and...
Does anyone have some engine bay pictures of an intermediate cj5 with a chevy V8 and saginaw PS? I am fabricating the steering in my 57 and...
I am starting to think about the doors and top. I like the little cab versions. I was wondering if a set of doors, a bikini top and a windjammer...
I have found the T15 exploded view drawing listing parts but I cannot locate a detailed "how to" for disassembly, reassembly? Does anyone have...
There always seems to be unending questions about the Chevy 4.3 V6. I have spent the past few months researching the 4.3 in an attempt to...
I just bought a used glass body and it has no provisions, holes, etc for door hinges. My 78 cj5 & 80 cj7 had external hinges I think?? but that...
What do you guys think is a better set up, block huggers or fender well? The block huggers are slick, but looks like everything is really tight,...
I may have located a T15 for the project. It is mated to a D20. >>>I thing I know the answer to this one, but here goes: Q: Will it mate...
In my 57 cj5, aren't the driveshaft to axle U-Joints 1310? If so, would a front driveshaft from an early K5 Blazer work in the rear location on my...
I know this has been covered, but my search tool results turned up nothing. I am re-doing a 57 cj5 and looking at used tub options (mine is...
Separate names with a comma.