Cool, Joe. I'd like to see the pump mounting when you get a chance. I was planning on talking to Herm about this and other things before buying,...
you could always buy the manual tire changer from harbor freight. That would make the job easier, but I'm with jeep2003... get a shop to do it......
Recently I noticed (remember, I've been hiding under a rock for years) that Herm's providing a Ford power steering conversion kit now. I like the...
oops, my bad, the spline count on the output shaft is different too... :oops: You'd either have to replace the output shaft as well or replace...
They are identical except for that input shaft, which last time I priced a new one plus the gears it meshes to, it was in excess of $500 for those...
gasket schmasket. :) Just use some blue rtv and you're good to go. don't use too much, or the excess will block the ports in and out of the...
yup... remove your adjusters and unthread bolt from the other half, look at the end of it... it will be stamped "L" or "R" on the inside end past...
old jeeps don't leak oil... they mark their territory.
what about the points and condenser? you mentioned all the electricals of the ignition except those key items. Are you sure your points are...
I'd be convinced to switch distributors if I had electronic replacement for the points/condenser. I really dig mine though, it's super easy to...
slide off the connector where it's at, cut the connector off the wires, crimp spades to the wires, and re-attach.
I forget the name for my distributor on my 225, it's not the one they put in 1970, it's the earlier one, with the hole in the side to set the...
my vote would be to toss it into the furnace and melt it down, but I'm very anti-automatic transmission.
Does anyone on here know what location I need to drill and tap on the SM420 to install a reverse light switch? Both my SM420's are pre-67, and...
Separate names with a comma.