Drained the fluid today in preparation for changing a front output shaft seal. Quite a bit of metal fuzz and flakes on the drain plug magnet....
Hi everyone, Im getting to the point in my custom frame build were I need to work on fuel lines. What does everyone recommend for fuel lines?...
Well a few months ago I finally started the much needed rebuild for the CJ. I have been putting this project off for a while, but now I'm out of...
Hey guys, I have a issue that i need advice on. The rear half of my frame is quite rusty, the rear frame rails are quite thin in spots and the...
Just out of pure curiosity (boredom?) what are the other intermediates seeing for fuel economy? I"m seeing 10-14 mpg with a TBI 258 t14...
I Just got my waggy power booster and master cylinder mounted and bleed. Now the brakes have a scary amount of assist,compleate lock up under...
Has anyone here used the black dimond or the 4wd hardware lift kit or have any experiences with them? Let me add that my CJ is quite heavy with a...
I have been looking into new lift springs for a while. Then i had an idea (bad idea???) I would remove all but the main and secondary leaf from...
Well i have had the CJ for 6 years now. So i figured its about time for a build thread! A little History I first got it when i was 16 (22 now)...
Hey guys, i got in a accident a last week that involved me hitting a curb at speed which threw off my alignment. I have a appointment for an...
Thought you guys would like to see some pics of my new tbi setup, i have a few bugs to fix but i like it so far! [IMG] [IMG] [IMG] [IMG]
I'm fed up with the electric oil pressure gages, wrong senders wrong gages. I'm thinking about going with a mechanical oil gage but I'm worried...
I tore down the top end of my engine to replace my lifters because they ticked when cold and at speed, as far as i know did everything right....
In about a month i will be switching to a 2bbl intake to go along with my mc2100 carb. This intake is water heated i am wondering if a 180*F...
Here are the brackets i made the its all made out of 2x2x1/8 angle iron. First the cad drawing and dimensions of the bracket: [IMG] [IMG] Bracket...
How much steering slop is normal for a manual steering box? How much slop did it have from the factory? I have about 2" of slop in the wheel. It...
I'm away from my jeep now, 300 miles to be exact and i was wondering if someone could measure how tall the stock bumper is? Thanks andy
I have a two part question... First i noticed on the 258 specs on the internet that the compression ratio increased over the years, how was that...
Has anyone installed an antisway bar on their jeep? I would like drive mine on the highway but I'm scared of the body roll. Does it make a...
My valve lifters have started ticking pretty badly lately, they have slowly gotten worse and worse. What kind of job is it to remove the lifters?...
Separate names with a comma.