After two years of woking on this restoration it's finally done. So I thought I would share a few pictures with those that are interested....
I just recieved some stock exhaust manifolds to replace the headers. The stock exhaust manifolds have a flat surface that the exhaust pipes...
Is the wiring diagram different on a 73 Renegade than a the wiring diagram on a standard cj.
I'm trying to bleed my brakes but when someone pushes on the brakes and I release the wheel cylinder valve nothing happens. I get no fluid and the...
This is a question best answered by a renegade ll owner. Does the hood blister have a pinstripe around the perimeter or is it just solid black.
I can't seem to find a lower radiator hose to fit my 225 v6 properly. The Gates 20355 kinks when cut and installed and this is the hose that is...
I can't see the timing mark when I put the timing light on it. Let me tell you what I've done so we're on the same page. I pulled the left side...
Which direction does the output shaft seal go. If I'm looking at the back of the transfer case does the metal surface face me or does the rubber...
The FSM says 5 degrees BTC is the correct setting. It also says that the timing is set with the vacuum advance disconnected. I did all of that...
Priming engine oil for start-up. Engine is oiling very well on right side rockerarms and barely oiling on left side rockers. Is something plugged...
On the valve stem side of the rocker arm on a 225 v6 there is a hardened piece of steel that comes in contact with the valve stem. It is easily...
Does anyone know why I would bend two pushrods after about 15 minutes of run time on a rebuilt 225 v6 engine. It has new lifters but I used the...
My 70 cj5 with a 225 v6 was running fine, I parked it in the garage for two weeks went to start it and all it does is backfire through the carb. I...
I know that the early renegade 2 wheels are made by American Racing Wheels in England and have a D shaped slot. It's the oval shaped slots from...
Is the purpose of the small hose between the water pump and water inlet to by-pass the thermostat untill it gets hot enough to open. This is on a...
I've read all the threads related to this subject and have gotten some conflicting statements. Maybe someone can help me with this problem that...
When I hooked my fuel gauge up I mistakenly connected the sending unit wire to the post that has the solid bar to the temp gauge. The fuel and...
Could someone tell me the initial setting for the two idle fuel-air mixture screws for the stock 2G carb. on a 225 v6. I can't find it anywhere in...
Huge mess all over garage floor. The hose from the water pump is 3/4" and the hose from the intake manifold is 5/8". Why are both connections to...
Started up a 225 v6 rebuild a couple times for a very brief period of time without any water in it. Just wanted to make sure everything worked...
Separate names with a comma.